Pics of Stock/ported Intakes and Stock/AJE K-member installed

[Bad Pony]

Here is a side-by-side of my stock and ported manifolds

http://personal.bhm.bellsouth.net/bhm/j/s/jsmithap/portbeforafter.jpg


and here is pics of the stock K-member and the AJE K-member.. the stuff around the X-pipe/header connection is gasket sealer lol.. *note* if you install JBA's weld the bolts to the headers for the x/h pipe hookup, it's not threaded like the stock manifold and a PITA to tighten.

http://personal.bhm.bellsouth.net/bhm/j/s/jsmithap/stockKmember2.jpg

http://personal.bhm.bellsouth.net/bhm/j/s/jsmithap/afterKmember.jpg

[spittincobra01]

Lookin good there Joey! Hey what springs are you runnin?

[98Cobretti]

Nice K-member, looks like it adds better access to the engine and headers. Is that a pain to install? Do you need to run tubular control arms when you switch the member or can you just stick with your stock parts on it?

[Bad Pony]

Haven't been in here in awhile guys.. I'm running Eibach Pro's and I'm still using the stock A-arms... I had it installed, no way I wanted to tackle that job...