shop recommendations for roll bar

grasshopper · 02-05-2004, 01:18 AM

I'll be in the greater Charlotte area this Saturday and was wondering if there was a preferred shop to visit. I'll actually be near Asheboro visiting a junk/salvage yard but it's not that far away and I need to get out in the car!!

Is there a club sponsor in the area? I'd like to talk to someone about installing a bolt-in 4 point roll bar in the convertible. I have been talking with a guy but his initial quote was higher than I expected and he hasn't installed one in a Mustang before. Any suggestions for a Charlotte area shop?

Hazman · 02-05-2004, 07:24 AM

If you want a bolt in for a vert the Autopower is a good way to go. Install takes about 6-8 hours or less with help. No trim to cut just the carpet and the rear seat support. This is a do it yourself project. Here is a link to a great hot to do it someone put up.
http://wingnutmotorsports.homestead.com/rollbar.html

If you want a custom welded bar contact Tom Lewis at Banana Motorsports in Columbia, SC.
http://www.bananamotorsports.com/
He is a member and post as 98banana. Everyone on here can attest that Tom builds strong stuff!!

If you go the bolt in route several of our vendors can get you the Autopower. I got mine through Maximum Motorsports on a club purchase.

Good Luck

redsnake99 · 02-05-2004, 11:29 PM

My roll bar is a custom one made by Jay Marshall from Jay Marshall Racing, in Monroe, near Charlotte. Check him out.

02-05-2004, 01:18 AM	#1
grasshopper SCMC Member Join Date: Mar 2003 Location: Chapel Hill, NC Posts: 65	shop recommendations for roll bar I'll be in the greater Charlotte area this Saturday and was wondering if there was a preferred shop to visit. I'll actually be near Asheboro visiting a junk/salvage yard but it's not that far away and I need to get out in the car!! Is there a club sponsor in the area? I'd like to talk to someone about installing a bolt-in 4 point roll bar in the convertible. I have been talking with a guy but his initial quote was higher than I expected and he hasn't installed one in a Mustang before. Any suggestions for a Charlotte area shop? __________________ Marc ter Horst 99 Green Vert

02-05-2004, 11:29 PM	#3
redsnake99 SCMC Member Join Date: Jun 2001 Location: NV, NY, SC Posts: 1,241	My roll bar is a custom one made by Jay Marshall from Jay Marshall Racing, in Monroe, near Charlotte. Check him out. __________________ Dave Stanfield - SCMC 424

02-05-2004, 07:24 AM	#2
Hazman Registered User Join Date: Sep 2002 Location: Harriman, TN Posts: 823	If you want a bolt in for a vert the Autopower is a good way to go. Install takes about 6-8 hours or less with help. No trim to cut just the carpet and the rear seat support. This is a do it yourself project. Here is a link to a great hot to do it someone put up. http://wingnutmotorsports.homestead.com/rollbar.html If you want a custom welded bar contact Tom Lewis at Banana Motorsports in Columbia, SC. http://www.bananamotorsports.com/ He is a member and post as 98banana. Everyone on here can attest that Tom builds strong stuff!! If you go the bolt in route several of our vendors can get you the Autopower. I got mine through Maximum Motorsports on a club purchase. Good Luck

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)